General guide Ritmo Slimline this is for start up only you will adjust later. Close enough will be fine for the water setting

Slimline B Pump
speed 10 Water 400 Speed 10 Water 350

Speed 9 Water 360. Speed 9 Water 310

Speed 8 Water 320. Speed 8. Water 280

Speed 7. Water 280. Speed 7 Water 240

Speed 6 Water 240. Speed 6 Water 200

Speed 5. Water 200. Speed 5. Water 160

We always start with a bit of water at the bottom of the mixing chamber so the first thing going through the rotor stator is water and wet mix .

We always start with a bit of water at the bottom of the mixing chamber so the first thing going through the rotor stator is water and wet mix .

Here we add material to the mixing zone on top of the small amount of water we have allready added. Please note we add a small amount to start in case of any material issues . Materials in the UK are very good and its been perfectly normal to empty a full bag into the chamber
Material test pipe available here

Always do this at ground level. 1 part at a time. Never up on the scaffold

1. Send material through pressure flange
2. Prime 1st material hose and send material through
3. Repeat & Prime 2nd material hose if required
4. Dip spray gun in water and send material through

The air tube setting tool click to buy makes an easy job of setting the silver air tube back to the correct distance

Remember when you are not spraying, unplug the compressor and release the air pressure or you will not be able to turn the machine on and off because the air on the gun will be controlling that.
Cleaning set available here

Cleaning gun and hose available here

Round file for ritmo

Keep the gun assembled to avoid losing parts

There is a cleaning tool for this or you can clean it by hand and use a Cat tongue trowel

Make sure to always clean this. The pressure gauge is vital when you understand what it does

Send a sponge ball through 2 times to make sure your hoses are kept clean